Earth and stones are the primary causes of belt breakage . Our 3D printed belt protectors are intended to limit projections coming from the ground or the rear wheel. They will allow you to increase the lifespan of your belt and thus stop repeated breakages. Printed in PLA-Carbon with a high-end 3D printer in order to have the highest level of finishes as well as very high resistance to stress.
- Printed in PLA-CF
- Screws supplied with the lower protection
- Original, 0.75" and 1.5" correspond to the size of your link
! Superior protection does not require dismantling of the suspension system!
- 100% compatible with all years of Sur-Ron Light Bee
- High resistance to stress
- Great resistance to humidity
- 3D printing with a high level of finish
- High resistance to bending
- Also helps prevent oil splashing on the disc when a primary kit is installed
"Jo & Will's Word"
With our training in industrial design , we have always been doubtful about the different 3D printing available for the Light Bee. Print quality, resistance to stress, medium heat and humidity. We therefore decided to develop our own 3D printing range ourselves and to invest in a high-end, latest generation printer. The goal is to offer you pieces with the best rendering and the highest possible quality . After numerous trials and tests, we finally put our 3D prints at your disposal and we guarantee their solidity!
JW Shop carries out all 3D printing with a latest generation, high-end printer. However, this is FDM printing and therefore the presence of small aesthetic defects is possible.